![]() This is why they went for mid ‘belly' channels in the 80’s especially on anything shorter than 6’4’. ![]() Doing this to an already flat and short board means you will end up with some negative curves even a type of dip or concave in the tail line. ![]() I can show you better on a board but this is the jist of it.īoard has to have a considerable amount of rocker thru mid to tail because as you cut them you are effectively ‘flattening' the tail section. Kind of hard to explain but the concept of those channels only works on with these main aspects. Putting a 6 set of channels on a board that short for those type of surf conditions won’t work. "Yeah all looks pretty good, except for channels. showed my mate the draft and this was his feedback. and I've effectively now been talked out of doing channels in favour of mofo deep concaves instead. though a bit of width works well in a lot of beachy conditions down here, as they're often more lump and chug-a-lug than bowl for the most part. ^^ thanks, and yes, cautious about going to wide with the tail.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |